The Chamber is manufactured and tested to suit the specifications.
The chamber is a triple wall. Inner both the walls are stainless steel.
The outer wall is mild steel powder coated. This construction avoids rusting
problems. Stainless Steel rod shelves – 2 nos will be provided with the chamber. The chamber is provided with the best air circulation to give better temperature uniformity. This is achieved by using one set of motor & blower in a baffle wall compartment to push treated air in the working chamber. This system gives better than 1 deg c. Temperature uniformity in the working chamber. Steam injection & heating system is from the backside, behind baffle wall. The air circulation blower is also fitted in this compartment only.
This arrangement helps to mix treated air and pass well-mixed air inside the working chamber. Due to the above system, the temperature in complete chamber remains equal. Insulation is provided in the unit to minimize losses. This increases the efficiency of the unit. The light is provided in the working chamber for proper illumination, having control switch at the top panel. The chamber is provided with a front door with a magnetic gasket to close the door properly. The complete assembly is fitted on base in such a way that any component can be replaced very easily.
- Temperature Range: 10°C to 60°C
- Humidity Range: 40% to 95% RH
- Temperature Accuracy: ± 1°C
- Humidity Accuracy: ± 3% RH
- Low water level circuit
- Heaters overload relay protector.
- Compressor overload protector
- The design of the chamber is most ideal to set conditions which give uniformity of temperature throughout the chamber and also saves valuable power consumption.
Capacity (Ltrs.) Inner Chamber Size (cm)
91 Litres 45 x 45 x 45
175 Litres 70 x 50 x 50
288 Litres 90 x 55 x 55
342 Litres 90 x 60 x 60
441 Litres 90 x 70 x 70
i) Direct RH Controller.
ii) RH Sensor Range 40 to 95% for Direct RH Controller.
Extra: Suitable voltage stabilizer